Applying Vinyl Siding Starter Strip

In order for the siding to be installed properly in a level fashion the starter strip at the bottom of the wall must be level.

Applying vinyl siding starter strip.

Vinyl siding starter strips. Mice bees and all sorts of other critters love making their home inside vinyl corner posts. From that point measure up 1 4 6 4mm less than the width of the starter strip and partially drive a nail at one corner. Installing inside corner.

Find the lowest corner of the old siding or sheathing on the house. Locate the lowest possible corner that has sheathing. Attach j channel trim strips around windows and doors and along the eaves. Hold a tape measure against the exterior wall and travel.

Cap the corner posts. Insulation for vinyl siding 1. How to install a vinyl siding starter strip step 1. Position starter strip with the top edge of chalk line and allow room for corner posts.

Nail the starter strip to the siding aligning the top of the strip with the chalk line. Partly drive a nail 11 2 in. This chalk line should be level and a consistent distance from the eaves or the top and bottom of the windows. Measure a spot that is 1 1 2 inches above the bottom edge of the sheathing at this lowest point using a tape.

Pull the zip tool down while simultaneously. Pop a level chalk line for the starter strip an inch or two above the bottom of the siding. Slide it into the corner and nail it every 16 in. Pull up as.

This video shows how to install a starter strip for vinyl and polymer siding installation. Insert the flat hooked end of the zip tool under the lip on the bottom most edge of the vinyl siding panel that rests on top of the starter strip. Be sure to center the nails in their slots to. Staret strip secures the first course of siding to the home.

13 simple vinyl siding installation tips use the wider starter strip. Determine the lowest point of the wall that will be sided. Snap a level chalk line for the first starter strip at the base of the wall no less than 8 inches above ground level after determining the lowest corner of the house. Snap each length of siding in place so that its bottom lip hooks under the starter strip.