Apply Vinyl Lettering Windex

They are all a little different but very helpful.

Apply vinyl lettering windex.

To apply a vinyl cut decal prepare the metal as above and wash with soap and water including new paint. If you re applying the decal to glass do not use windex or other ammonia based cleaners. Whether you are applying a small decal such as a college sticker or parking permit or adhering a large rear window graphic choosing the right tools in the best weather conditions and taking plenty of time will assure effective decal application. Wipe away the excess windex and let the decals take a set.

Peel off the wax paper using a friend to help with bigger decals. This is key and it s a good time to walk away from the car. If air bubbles occur puncture with a pin and smooth down. How to apply vinyl lettering racing stripes vinyl stickers vinyl decals pinstripes and more.

Surface should be clean and dry before applying vinyl lettering. The adhesive on the back of the vinyl lettering should stick well to your surface if it has been properly cleaned and prepped. Remove the wax paper. The ammonia interferes with the adhesive.

Use a little rubbing alcohol to clean the area where the decal will be applied. Peel the backing paper from the decal. Squeegee windex from under the decal beginning in the center and working outward. If you have never applied vinyl die cut decals it is recommend to do a little research online.

With some elbow grease the adhesive can be removed. Only remove the wax paper when you are ready to apply the decal to prevent dirt from getting on the adhesive surface. Get the best results when applying car window decals by following expert tips. Do not use windex in an aerosol can.

Use the squeegee to squeeze out all the windex and air bubbles from underneath the decal. Mild detergents or solvents can be used to remove wax grease tar etc. Apply vinyl lettering to your surface lower the mask layer and using your squeegee press firmly at a 45 degree angle starting from the middle and going out. Apply rubbing alcohol to remove any remaining oils or waxes from the vehicle s surface.

Apply water to the back side of the. Such as metal glass plastic wood wall board etc. Vinyl can be applied to any smooth surface. Glass cleaners such as windex can be used to remove dirt grit and water soluble substances.

The vinyl will not stick as well to any oil or waxy surface. There are many youtube videos and websites that have great tutorials on how to apply vinyl die cut decals.